User guide

A-37
Cisco H.323 Signaling Interface User Guide
OL-2156-04 Rev. A1
Appendix A MML User Interface and Command Reference
stp-call
stp-call
The stp-call command terminates a currently active call by forcing a release of the call.
Disconnect/release messages are sent in both directions.
stp-call:callref=x
stp-call:all
Syntax Description
Examples In the following example, the command terminates a currently active call by forcing a release of the call
with a callref of 33.
gw mml> stp-call:callref=33
H323 Signaling Interface Thu Dec 14 16:43:54 2000
M SUCC
Stopped call 33
Related Commands
stp-callproc
The stp-callproc command stops further call processing by immediately terminating the handling of new
call requests.
stp-callproc[:timeout=T]
Syntax Description
Examples In the following example, the command stops further call processing by immediately terminating the
handling of new call requests:
gw mml> stp-callproc
H323 Signaling Interface Thu Dec 14 16:27:07 2000
M SUCC
callref Refers to a positive integer.
all Stops all calls.
Command Description
rtrv-calls Displays all actively connected calls.
timeout If no timeout period is provided, existing calls are released immediately. If
a timeout period is provided, existing calls are released after the specified
amount of time has elapsed. When all calls have been released, a
notification message is sent to the craft terminal.
T T is in seconds.