User guide

A-32
Cisco H.323 Signaling Interface User Guide
OL-2156-04 Rev. A1
Appendix A MML User Interface and Command Reference
set-gapping
Related Commands
set-gapping
The set-gapping command sets the type of calls to be gapped.
set-gapping: inc | otg | both : calltype=normal | all, percent=number
Syntax Description
Usage Guidelines If call gapping is set to 100 percent, all calls are gapped irrespective of the normal or all parameter
setting.
If the overload condition is active and call gapping is active, the higher of the two percentage values
determines whether new call attempts are accepted or rejected.
Examples In the following example, the command sets all calls to be gapped and specifies that 50 percent of the
calls be rejected due to call gapping:
gw mml> set-gapping:both:calltype=all,percent=50
H323 Signaling Interface Day Mon 1 hh:mm:ss YYYY
M SUCC
Successfully set gapping for target 'both', calltype 'all', and percentage 50
Related Commands
set-log
The set-log command sets the logging level of a package or all packages.
set-log:package:level=level, [confirm]
set-log:all:level=level, [confirm]
Command Description
rtrv-dest Retrieves status information about the IP links and E-ISUP signaling
path to the PGW 2200.
inc Gaps calls from the H.323 network.
otg Gaps calls from the PSTN over E-ISUP.
both Gaps calls originating from either side.
normal Gaps all calls except priority and emergency calls.
all Gaps calls of all types.
number Specifies the percentage of calls rejected due to call gapping.
Command Description
rtrv-gapping Retrieves information about overload-triggered call gapping.