Operating instructions

optiClient5d_Konfiguration.fm
A31003-G2550-A100-6-76A9, 04/2005
optiClient 130 V5.0 , Administrator Documentation and Operating Instructions
4-29
Nur für den internen Gebrauch
Configuration and Settings
Settings for Provider Modules
4.4 Settings for Provider Modules
Provider modules is the term used in optiClient 130 to designate the modules that enable opti-
Client 130 to communicate with a connected communication system, which in turn provides ac-
cess to specific media services on the network. Communication systems typically enable you to
● use telephony services (e.g., with PBX systems such as HiPath 3000/4000/5000)
● send emails
● operate desktop telephony devices with optiClient 130
Special settings must be configured to ensure smooth access to the communication system
and associated communication services. The type and scope of these settings depend on the
communication system.
The specific provider modules available in optiClient 130 depend on the prevailing situation on
site (Installation/Licensing, etc.), so not all of the settings for provider modules described here
may be relevant for "your" optiClient 130:
● If the optiClient 130 is directly connected to the HiPath 3000/4000/5000, you will find a de-
scription of the settings for optiClient 130 in the section Settings for the HiPath Provider on
HiPath 3000/4000/5000.
● If you are using desktop telephones (connected to a HiPath 3000/4000/5000) over optiCli-
ent 130, you will find a description of the settings for optiClient 130 in the section Settings
for the CTI Provider on HiPath 3000/4000/5000.
● Settings for the Sendmail Provider
4.4.1 Settings for the Sendmail Provider
To send email directly to a contact from one of the directories or from the Contact list, you will
need the Sendmail Provider. This starts the mail client (e.g., Outlook) that is installed / config-
ured on the PC and uses the email address of the contact as the recipient address for a new
email message.
The Sendmail Provider module is added by default after the optiClient 130 is started up and
can thus be used. At present, there are no further settings to configure for the Sendmail Pro-
vider. Therefore, when you choose Settings - Provider modules - Sendmail Provider, no
configuration parameters appear.