Operating instructions

optiClient5d_Konfiguration.fm
A31003-G2550-A100-6-76A9, 04/2005
optiClient 130 V5.0 , Administrator Documentation and Operating Instructions
4-15
Nur für den internen Gebrauch
Configuration and Settings
Settings for the Main Program
4.2.7 Settings for Central Configuration
In cases where a Deployment Service (DLS or central configuration) is available on the net-
work for an optiClient 130 installation, the settings for the optiClient 130 can also be stored cen-
trally. In such cases, the parameters for accessing the central configuration must be entered in
the optiClient 130 so that the centrally stored parameters can be used.
To edit the settings for the central configuration, open Main program - Central configuration.
Display
> If a central configuration is available for your installation, enable the option Use central
configuration.
> Enter the IP address for the DLS Server and the relevant port numbers. The DLS Port is
the port number used for accessing the central server. DLC Port is the local port number
where the optiClient 130 PC responds to queries from the central server.
>
These settings are entered by default if you specified that a central configuration
would be used (where applicable, also by specifying the server) during optiClient
130 installation.
>
Please refer to the section Starting optiClient 130 for the First Time with Active Cen-
tral Configuration (DLS) for special information on using the central configuration for
configuring or logging on users for the first time.