Operating instructions

First Steps, Display Modes and General Operation Nur für den internen Gebrauch

A31003-G2550-A100-6-76A9, 04/2005

3-16 optiClient 130 V5.0 , Administrator Documentation and Operating Instructions

optiClient5d_Anzeige.fm

General optiClient 130 Operation

3.3.1.4 The optiClient 130 Forwarding menu

In order to forward connection requests at times when you are absent, you can define call for-

warding in optiClient 130 for various types of forwarding and then enable or disable the feature

as needed. The provider connected defines which types of forwarding are available.

Display (example)

Volume control:

Push the slider right (louder) or left (softer) to adjust the volume of the...

● Ring tone when optiClient 130 is in an idle state or a connection request is

received.

● loudspeaker when a connection is in progress and a loudspeaker is active.

● handset when a connection is active, a call is being conducted via the hand-

set, and the loudspeaker is not turned on.

● headset when a connection is active, a call is being conducted via the head-

set, and the loudspeaker is not turned on.

Volume menu:

To adjust the volume of the ring tone, loudspeaker, handset or headset irre-

spective of your current optiClient 130 call state, open the Volume menu by click-

ing the volume button (to the right of the slider). You can adjust the volume of the

ringer, loudspeaker, handset or headset here.

The headset button and headset volume control will only be available to you if you

are using a Siemens optiPoint handset with a headset extension and if this audio de-

vice has also been configured in the active audio scheme.