Operating instructions

Making Calls with the HiPath 3000/4000/5000 Nur für den internen Gebrauch
A31003-G2550-A100-6-76A9, 04/2005
10-16 optiClient 130 V5.0 , Administrator Documentation and Operating Instructions
optiClient5d_TelefonieHp4.fm
Settings for the CTI Provider on HiPath 3000/4000/5000
> Enter the Extension number of the device at which you can be reached in the optiClient
130 network and the Password configured (if necessary) on the communication system
for your extension number. The password can be obtained from the administrator of the
communication system.
> If you work as an ACD agent, enter your ACD agent number.
> The Emergency call number field is intended for future expansion (currently unassigned).
10.2.3 Network Access Settings
Network access settings (location information) are needed for setting up a direct connection
from optiClient 130 directories or call lists. If these settings are not configured properly, you may
encounter problems when setting up connections. To configure the settings for the network ac-
cess, select Provider modules - HiPath Provider - Network access.
Display
> Enter the code for the international prefix for the location under Country code. Omit the
leading zero when entering the Area code.
> Enter the HiPath 4000 system identification number. This system ID number identifies
internal call numbers in the directories that only set up internal connections when selected.
> Under Trunk code, enter the code that was configured for network access on the
connected communication system.
> Under Prefix for local calls/Long-distance calls/International calls, enter the network
operator code for the type of call concerned. This data is independent of the configuration
for the connected connection system and is determined by the network operator. The
example shows the prefix numbers for the network operator in Germany. Other prefixes
may apply in other countries.