Operating instructions

optiClient5d_TelefonieHp4.fm
A31003-G2550-A100-6-76A9, 04/2005
optiClient 130 V5.0 , Administrator Documentation and Operating Instructions
10-9
Nur für den internen Gebrauch
Making Calls with the HiPath 3000/4000/5000
Settings for the HiPath Provider on HiPath 3000/4000/5000
Display
> Following a failover to the fallback communication system, automatic and cyclical attempts
are made to reestablish a connection to the main communication system. The option
Minimum number of successful connection attempts to primary system to switch
back defines after how many successful connection attempts the main communication
system can be considered ready for operation again. The defined Waiting time between
connection attempts (sec.) also applies here.
> If you want to prevent an automatic switchback to the main communication system even
after successful connection attempts, enable the option No automatic switchback to
primary system.
10.1.7 Settings for Bandwidth Reduction
In order to optimize voice transmission quality, you can make several settings to match the cur-
rent environment of your network installation. To do this, select HiPath Provider - Bandwidth
reduction.
Display
> When operating the optiClient 130 at the HiPath 4000, voice packets are exchanged over
the network by default directly between the communication partners (Direct Media Connect
- DMC). DMC can optionally be disabled by setting the option Shut down DMC. Voice
packets are then no longer exchanged directly between the communication partners, but
via HiPath 4000. This option may be enabled when operating the optiClient 130 from home
(teleworking).
This option is not relevant when operating the optiClient 130 at a HiPath 3000.