Operating instructions

Making Calls with the HiPath 3000/4000/5000 Nur für den internen Gebrauch
A31003-G2550-A100-6-76A9, 04/2005
10-8 optiClient 130 V5.0 , Administrator Documentation and Operating Instructions
optiClient5d_TelefonieHp4.fm
Settings for the HiPath Provider on HiPath 3000/4000/5000
10.1.5 Settings for Fallback Network Access
Network access settings (location information) are needed for setting up a direct connection
from optiClient 130 directories or call lists. If these settings are not configured properly, you may
encounter problems when setting up connections. To configure the settings for the Fallback net-
work access, select Provider modules - HiPath Provider - Fallback network access.
Display
> The meanings of the parameters for the fallback network access correspond to those of the
main connection; see also Settings for Main Network Access.
10.1.6 Settings for Failover
If the optiClient 130 is being operated at a communication system with a Fallback system, then
the optiClient 130 will be switched over automatically to the fallback communication system if
the main communication system fails. In order to restore the connection when the main com-
munication system becomes available again, you will need to define various settings here: To
do this, select HiPath Provider - Failover:
>
The settings for the main network access must always be made, since it is not pos-
sible to operate the optiClient 130 without these parameters. If the optiClient 130 is
being operated at a communication system with a Fallback system, then the para-
meters for the fallback network access must also be configured on the fallback com-
munication system to enable smooth operation of the optiClient 130 (see also Set-
tings for Main Network Access).