Operating instructions

optiClient5d_TelefonieHp4.fm
A31003-G2550-A100-6-76A9, 04/2005
optiClient 130 V5.0 , Administrator Documentation and Operating Instructions
10-7
Nur für den internen Gebrauch
Making Calls with the HiPath 3000/4000/5000
Settings for the HiPath Provider on HiPath 3000/4000/5000
> Under Prefix for local calls/Long-distance calls/International calls, enter the network
operator code for the type of call concerned. This data is independent of the configuration
for the connected connection system and is determined by the network operator. The
example shows the prefix numbers for the network operator in Germany. Other prefixes
may apply in other countries.
10.1.4 Settings for the Fallback connection
To edit the parameters for the Fallback connection, select the entry Provider modules - HiPath
Provider Fallback connection. Enter the information here that defines your connection bet-
ween optiClient 130 and your fallback communication system:
Display
> Select your fallback communication system as the Type.
> The meanings of the other parameters for the fallback connection correspond to those of
the main connection; see also Settings for the Main Connection.
>
The settings for the main connection must always be made, since it is not possible
to operate the optiClient 130 without these parameters. If the optiClient 130 is being
operated at a communication system with a Fallback system, then the parameters
for the fallback connection must also be configured on the fallback communication
system to enable smooth operation of the optiClient 130 (see also Settings for the
Main Connection).