Operating instructions

Making Calls with the HiPath 3000/4000/5000 Nur für den internen Gebrauch
A31003-G2550-A100-6-76A9, 04/2005
10-6 optiClient 130 V5.0 , Administrator Documentation and Operating Instructions
optiClient5d_TelefonieHp4.fm
Settings for the HiPath Provider on HiPath 3000/4000/5000
> For the IP connection of the optiClient 130, the Own IP address must be known. If the
optiClient 130 is connected to a network adapter to which a unique IP address has been
assigned, select the setting Specify automatically here. If multiple IP addresses have
been assigned to the network adapter, all such addresses will be shown in the list box, and
you can then select the one you want.
10.1.3 Settings for Main Network Access
Network access settings (location information) are needed for setting up a direct connection
from optiClient 130 directories or call lists. If these settings are not configured properly, you may
encounter problems when setting up connections. To configure the settings for the main net-
work access, select Provider modules - HiPath Provider - Main network access.
Display
> Enter the code for the international prefix for the location under Country code. Omit the
leading zero when entering the Area code.
> Enter the HiPath 4000 system identification number. This system ID number identifies
internal call numbers in the directories that only set up internal connections when selected.
> Under Trunk code, enter the code that was configured for network access on the
connected communication system.
>
The settings for the main network access must always be made, since it is not pos-
sible to operate the optiClient 130 without these parameters. If the optiClient 130 is
being operated at a communication system with a Fallback system, then the para-
meters for the fallback network access must also be configured on the fallback com-
munication system to enable smooth operation of the optiClient 130 (see also Set-
tings for Fallback Network Access).