Operating instructions

optiClient5d_TelefonieHp4.fm
A31003-G2550-A100-6-76A9, 04/2005
optiClient 130 V5.0 , Administrator Documentation and Operating Instructions
10-5
Nur für den internen Gebrauch
Making Calls with the HiPath 3000/4000/5000
Settings for the HiPath Provider on HiPath 3000/4000/5000
10.1.2 Settings for the Main Connection
To edit the parameters for the main connection, select the entry Provider modules - HiPath
Provider - Main Connection. Enter the information here that defines your connection between
optiClient 130 and your main communication system HiPath 3000/4000/5000:
Display
> Select your main communication system as the Type. The available communication
systems are HiPath 3000 and HiPath 4000.
Enter the IP address of the communication system gatekeeper in the Gatekeeper field.
> Enter the Extension number at which you can be reached in the optiClient 130 network
and the Password configured (if necessary) for your extension number on the
communication system. The password can be obtained from the administrator of the
communication system.
> If you work as an ACD agent, enter your ACD agent number.
> The Emergency call number field is intended for future expansion (currently unassigned).
> In the Security mode list box, select the setting that is set as the security mode on the
connected communication system. More information can be obtained from the
Administrator of the connected communication system.
> In the Gatekeeper Security ID field, enter the ID as configured on your connected
communication system. More information can be obtained from the Administrator of the
connected communication system.
>
The settings for the main connection must always be made, since it is not possible
to operate the optiClient 130 without these parameters. If the optiClient 130 is being
operated at a communication system with a Fallback system, then the parameters
for the fallback connection must likewise be configured on the fallback communicati-
on system to enable smooth operation of the optiClient 130 (see also Settings for the
Fallback connection).