Datasheet

© 2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public. Page 8 of 14
Feature Description
Dynamic Host Configuration
Protocol (DHCP) (options 66
and 67)
(DHCP) options facilitate tighter control from a central point (DHCP server) to obtain IP address and perform auto-
configuration (with configuration file download)
Text-editable config files Config files can be edited with a text editor and downloaded to another switch, facilitating easier mass deployment
Smartports Simplified configuration of QoS and security capabilities
Auto Smartports Automatically applies the intelligence delivered through the Smartports roles to the port based on the devices
discovered over Cisco Discovery Protocol or LLDP-MED. This facilitates zero touch deployments.
Cloud services Support for FindIT Network Discovery Utility and Cisco OnPlus™ technology
Localization Localization of GUI and documentation into multiple languages
Other management HTTP, RADIUS, port mirroring, TFTP upgrade, DHCP client, BOOTP, SNTP, ping, syslog
Power Efficiency
EEE compliant (802.3az) Supports 802.3az on all copper Gigabit Ethernet ports (SG200-xx models)
Not supported on SG200-08 and SG200-08P models
Energy Detect mode Automatically turns off power on Gigabit Ethernet RJ-45 port when the switch detects a link down
Active mode is resumed without loss of any packets when the switch detects that the link is back up
Cable length detection Adjusts the signal strength based on the cable length. Reduces the power consumption for cables shorter than 10 m.
General
Jumbo frames Frame sizes up to 10 KB supported on 10/100 and Gigabit Ethernet interfaces
(9 KB for SG200-08 and SG200-08P)
MAC table Up to 8000 MAC addresses
Discovery
Link Layer Discovery Protocol
(LLDP) (802.1ab) with LLDP-
MED extensions
LLDP allows the switch to advertise its identification, configuration, and capabilities to neighboring devices, which
store the data in an MIB. LLDP-MED is an enhancement to LLDP that adds the extensions needed for IP phones.
Cisco Discovery Protocol The switch advertises itself using the Cisco Discovery Protocol. It also learns the connected device and its
characteristics via this protocol.
Auto Smartports Automatically applies the intelligence delivered through the Smartports roles to the port based on the devices
discovered over Cisco Discovery Protocol or LLDP-MED. This capability facilitates zero-touch deployments.
Bonjour The switch advertises itself using the Bonjour protocol
Power over Ethernet (PoE)
Maximum power of 15.4W to any 10/100 or Gigabit Ethernet base port supporting PoE. The total power available for
PoE per switch is as follows:
Model Power Dedicated to PoE
Number of Ports That Support
PoE
SF200-24P 100W 12
SF200-24FP 180W 24
SF200-48P 180W 24
SG200-08P 32W 4
SG200-10FP 62W 8
SG200-26P 100W 12
SG200-26FP 180W 24
SG200-50P 180W 24
IEEE 802.3af PoE delivered
on half of the RJ-45 ports
within the listed power
budgets
SG200-50FP 375W 48
Model Power Savings Mode
Power
Consumption:
Worst Case Heat Dissipation (BTU/hr)
Power consumption
SF200-24 Energy Detect 110V/0.272A/13.7
W
220V/0.169A/14.5
W
49.5