Datasheet

26
Cisco SFP and SFP+ Transceiver Module Installation Notes
78-15160-07
Installing SFP and SFP+ Transceiver Modules
Step 7 Press the SFP into the slot firmly with your thumb as shown in Figure 9.
Note For SFP transceiver modules equipped with an actuator latch, you must press firmly on both the
transceiver faceplate and the actuator button to ensure that the transceiver is properly latched in
the socket.
Figure 9 Latching the SFP
Step 8
To verify that the SFP is seated and latched properly:
a. Grasp the SFP as shown in Figure 10 and try to remove it without releasing the latch.
b. If the SFP can not be removed, it is installed and seated properly. If the SFP can be removed, reinsert
it and press harder with your thumb, repeating if necessary until it is latched securely into the socket.
Figure 10 Verifying SFP Installation
192406
192383