Specifications

2-74

Cisco SCE 8000 CLI Command Reference

Chapter 2 CLI Command Reference

clear interface range

Clears all the specified interfaces.

clear interface range interface-type [sce-id/]bay-range/interface-range

Syntax Description

Command Default None

Command Modes Privileged EXEC

Command History This table includes the following release-specific history entries:

Usage Guidelines The clear interface range command clears a group of interfaces with one command, with the limitation

that all the interfaces in the group must be of the same physical and logical type.

• For the Cisco SCE 8000 10GBE platform, use the following command syntax:

clear interface range tengigabitethernet sce-id/bay-range/0

• For the Cisco SCE 8000 GBE platform traffic ports, use the following command syntax (the bay

numbers are in the range of 0-1):

clear interface range gigabitethernet sce-id/bay-range/interface-range

interface-type For the Cisco SCE 8000 10GBE, enter a value of tengigabitethernet.

For the Cisco SCE 8000 GBE traffic ports (in bays 0 and 1), enter a value

of gigabitethernet.

For the Cisco SCE 8000 GBE cascade ports (in bays 2 and 3), enter a value

of tengigabitethernet.

bay-range For the Cisco SCE 8000 10GBE, specify the range of bays in the format

bay1-bay2, where the overall range of possible bay numbers is 0-3.

For the Cisco SCE 8000 GBE traffic ports, enter a value of 0, 1, or 0-1.

For the Cisco SCE 8000 GBE cascade ports, enter a value of 2, 3, or 2-3.

interface-range For the Cisco SCE 8000 10GBE, enter a value of 0 (cannot be a range).

For the Cisco SCE 8000 GBE traffic ports, specify the range of ports in the

format port1-port2, where the overall range of possible port numbers is 0 to

For the Cisco SCE 8000 GBE cascade ports, enter a value of 0 (cannot be a

range).

sce-id In an installation of two cascaded SCE 8000 GBE platforms, identifies the

specific SCE platform of the cascaded pair. Enter a value of 0 or 1.

Release Modification

3.5.5 This command was introduced.