Specifications

2-34
Cisco SCE 2000 and SCE 1000 CLI Command Reference
OL-26797-03
Chapter 2 CLI Command Reference
attack-filter subscriber-notification ports
attack-filter subscriber-notification ports
Specifies a port as subscriber notification port. TCP traffic from the subscriber side to this port will never
be blocked by the attack filter, leaving it always available for subscriber notification. Use the no form of
this command to remove the port from the subscriber notification port list.
attack-filter subscriber-notification ports port
no attack-filter subscriber-notification ports port
Syntax Description
Command Default This command has no default settings.
Command Modes Linecard Interface Configuration
Command History This table includes the following release-specific history entries:
Usage Guidelines Use this command to configure the port to be used for subscriber notification as configured using the
attack-filter and attack-detector <number> commands.
Authorization: admin
Examples The following example specifies port 100 as the subscriber notification port.
SCE>enable 10
Password:<cisco>
SCE#config
SCE(config)#interface linecard 0
SCE(config if)#attack-filter subscriber-notification ports 100

SCE(config if)#
Related Commands
port Port number. One port can be specified as the subscriber notification port.
Release Modification
2.5.7 This command was introduced.
Command Description
attack-detector
default
Defines default thresholds and attack handling action.
attack-detector
<number>
Configures a specific attack detector for a particular attack type
(protocol/attack direction/side) with the assigned number.
show interface
linecard attack-filter
Displays the attack filtering configuration.