Specifications

2-553
Cisco SCE 2000 and SCE 1000 CLI Command Reference
OL-26797-03
Chapter 2 CLI Command Reference
vas-traffic-forwarding vas server-group
vas-traffic-forwarding vas server-group
Adds servers to and removes them from a specified VAS server group. Use the no form of this command
to remove a specified server from the VAS server group.
vas-traffic-forwarding vas server-group group-number server-id server-number
no vas-traffic-forwarding vas server-group group-number server-id server-number
Syntax Description
Command Default This command has no default settings.
Command Modes Interface Linecard Configuration
Command History This table includes the following release-specific history entries:
Usage Guidelines The user may define up to eight VAS server groups. Each VAS server group has the following
parameters:
• Server Group ID
• A list of VAS servers attached to this group.
• Failure detection — minimum number of active servers required for this group so it will be
considered to be Active. If the number of active servers goes below this minimum, the group will be
in Failure state.
• Failure action — action performed on all new data flows that should be mapped to this Server Group
while it is in Failure state.
If no VAS server ID is specified in the no form of the command, all servers are removed from the server
group and all group parameters (failure detection and action) are set to the default values (see
VAS-traffic-forwarding VAS server-group failure ).
Authorization: admin
Examples The following examples illustrate how to add servers to and remove servers from a specified VAS server
group:
Example 1
This example shows how to add VAS server 5 to VAS server group 1.
group-number The ID number of the VAS server group.
server-number The ID number of the VAS server.
Release Modification
3.0.0 This command was introduced.