Specifications

2-545
Cisco SCE 2000 and SCE 1000 CLI Command Reference
OL-26797-03
Chapter 2 CLI Command Reference
vas-traffic-forwarding traffic-link auto-select
failed VAS server group on both links, the SCE platform will flip continuously between the links. To
avoid the constant flip between the links in such a case, it is recommended to configure a
link-switch-delay time greater than 3 minutes.
To specify the link on which to transmit VAS traffic after a system reload and when in auto-select mode
(the active VAS link), use the initial-selection option. Note that when executed, this command triggers
an immediate link switch if the currently active VAS traffic link used is different from the one specified
in the command.
Use the default form of the command to set either the link-switch-delay or the initial-selection to the
default value. You can also use the no form of the command for the same purpose, since it removes the
configured value, which results in the default value being restored.
Authorization: admin
Examples The following examples show how to use this command.
Example 1
This example shows how to set the initial-selection to link-0.
SCE>enable 10
Password:<cisco>
SCE#config
SCE(config)#interface linecard 0
SCE(config if)#vas-traffic-forwarding traffic-link auto-select initial-selection link-0

SCE(config if)#
Example 2
This example shows how to set the link-switch-delay to 60 seconds.
SCE>enable 10
Password:<cisco>
SCE#config
SCE(config)#interface linecard 0
SCE(config if)#vas-traffic-forwarding traffic-link auto-select link-switch-delay 60

SCE(config if)#
Related Commands Command Description
vas-traffic-forwarding
vas traffic-link
show interface
linecard
vas-traffic-forwarding
Displays information regarding VAS configuration and operational status
summary.