Specifications

2-544
Cisco SCE 2000 and SCE 1000 CLI Command Reference
OL-26797-03
Chapter 2 CLI Command Reference
vas-traffic-forwarding traffic-link auto-select
vas-traffic-forwarding traffic-link auto-select
Configures the VAS traffic link for VAS over 10G.
vas-traffic-forwarding traffic-link auto-select [link-switch-delay switch-time | initial-selection
{link-0|link-1 }]
no vas-traffic-forwarding traffic-link auto-select [link-switch-delay|initial-selection]
default vas-traffic-forwarding traffic-link auto-select [link-switch-delay|initial-selection]
Syntax Description
Command Default Default switch-time = 30 seconds
Default traffic link = Link-1
Command Modes Interface Linecard Configuration
Command History This table includes the following release-specific history entries:
Usage Guidelines For VAS over 10G, since the link used for forwarding VAS traffic may change automatically due to a
failover situation, the following options must be configured:
• Set the VAS traffic link to auto-select, so that the system can select the link connected to the active
7600/VAS servers system.
• Specify the minimum time allowed between two consecutive link switches.
• Specify the link on which to transmit VAS traffic after a system reload and when in auto-select mode
To set the VAS traffic link to auto-select, use the basic command with no options (the same as using the
VAS-traffic-forwarding VAS traffic-link command and specifying auto-select )
. To set the minimum time allowed between two consecutive link switches, use the link-switch-delay
option. In 10G topology, the default delay between two consecutive link switches (30 seconds) is less
than the time it takes for the health check to fail. This means that in cases where there is at least one
switch-time The time in seconds to delay between two consecutive link switches on
initial health check state.
initial-selection Enter the link number to be set as the active VAS link (the link on which to
transmit VAS traffic after a system reload and when working in auto-select
mode).
• Link-0
• Link-1
Release Modification
3.0.3 This command was introduced.