Specifications

2-542
Cisco SCE 2000 and SCE 1000 CLI Command Reference
OL-26797-03
Chapter 2 CLI Command Reference
vas-traffic-forwarding traffic-link
vas-traffic-forwarding traffic-link
Configures the link on which to transmit VAS traffic (the link to which the VAS servers are connected).
Use the no form of the command to remove the VAS link configuration and revert to the VAS link
defaults.
vas-traffic-forwarding traffic-link {link-0|link-1|auto-select}
no vas-traffic-forwarding traffic-link
Syntax Description
Command Default Default traffic link = Link-1
Command Modes Interface Linecard Configuration
Command History This table includes the following release-specific history entries:
Usage Guidelines Use the auto-select keyword with VAS over 10G. For VAS over 10G, the VAS link should always be set
to auto-select, so that the system can switch to the backup link when necessary.
Note The VAS traffic link should be in Forwarding mode.
Authorization: admin
Examples This example shows how to configure link 0 for VAS traffic.
SCE>enable 10
Password:<cisco>
SCE#config
SCE(config)#interface linecard 0
SCE(config if)#vas-traffic-forwarding traffic-link link-0

SCE(config if)#
Enter the link number on which to transmit VAS traffic
• Link-0
• Link-1
• auto-select : the active VAS link is selected by the system
Release Modification
3.0.0 This command was introduced.