Specifications

2-320
Cisco SCE 2000 and SCE 1000 CLI Command Reference
OL-26797-03
Chapter 2 CLI Command Reference
show interface linecard cascade connection-status
show interface linecard cascade connection-status
Displays information regarding the connection between two cascaded SCE 2000 platforms, using the
cascade interfaces.
show interface linecard slot-number cascade connection-status
Syntax Description
Command Default This command has no default settings.
Command Modes User EXEC
Command History This table includes the following release-specific history entries:
Usage Guidelines Authorization: viewer
Examples In order to assist the user when installing a cascaded system and to prevent wrong cabling, this command
provides information on the cascade connectivity.
Example 1
The following example shows the output of this command in the case of two cascaded Cisco SCE
platforms where the cascade interfaces have not been connected correctly.
SCE>enable 5
Password:<cisco>
SCE>show interface linecard 0 cascade connection-status
SCE is improperly connected to peer
Please verify that each cascade port is connected to the correct port of the peer SCE.
Note that in the current topology, the SCE must be connected to its peer as follows:
Port 0/3 must be connected to port 0/4 at peer
Port 0/4 must be connected to port 0/3 at peer
SCE>
Example 2
The following example shows the output of this command in the case of two cascaded Cisco SCE
platforms where the cascade interfaces have been connected correctly.
SCE>enable 5
Password:<cisco>
SCE>show interface linecard 0 cascade connection-status
SCE is connected to peer
SCE>
slot-number The number of the identified slot. Enter a value of 0.
Release Modification
3.6.x This command was introduced.