Specifications

2-315
Cisco SCE 2000 and SCE 1000 CLI Command Reference
OL-26797-03
Chapter 2 CLI Command Reference
show interface linecard attack-detector
show interface linecard attack-detector
Displays the configuration of the specified attack detector.
show interface linecard slot-number attack-detector [default|all]
show interface linecard slot-number attack-detector attack-detector
Syntax Description
Command Default This command has no default settings.
Command Modes User EXEC
Command History This table includes the following release-specific history entries:
Usage Guidelines Use the all keyword to display the configuration of all existing attack detectors.
Use the default keyword to display default attack detector configuration.
The following information is displayed:
• Protocol Side — Whether the attack detector applies to attacks originating at the subscriber or
network side.
• Direction — Whether the attack detector applies to single sided or dual sided attacks.
• Action to take if an attack is detected.
• Thresholds:
– open-flows-rate — Default threshold for rate of open flows (new open flows per second).
– suspected-flows-rate — Default threshold for rate of suspected DDoS flows (new suspected
flows per second).
– suspected-flows-ratio — Default threshold for ratio of suspected flow rate to open flow rate.
• Subscriber notification — enabled or disabled.
• Alarm — sending an SNMP trap enabled or disabled.
Authorization: viewer
slot-number The number of the identified slot. Enter a value of 0.
attack-detector The number of the specific attack detector to be displayed.
all Displays the configuration of all existing attack detectors
default Displays the default attack detector configuration.
Release Modification
2.5.7 This command was introduced.