Specifications

2-299
Cisco SCE 2000 and SCE 1000 CLI Command Reference
OL-26797-03
Chapter 2 CLI Command Reference
setup
• Domain Name Server configuration: default domain name and IP address (up to 3)
• RDR-formatter destination: IP address and TCP port number
• Access Control Lists: up to 100 lists, with 20 IP addresses in each list, each entry can be designated
as permitted or denied.
Create ACLs for IP access, Telnet access, SNMP GET community access, and SNMP SET
community access as needed:
• SNMP configuration: Define the following:
– GET community names (up to 20)
– SET community names (up to 20)
– trap managers (up to 20): IP address, community string, version
– name of system manager
• Topology configuration: Define the following:
– connection mode
– administrative status after abnormal reboot
– SCE 1000 Platform:
– link-bypass mode when operational
– redundancy
– link-bypass mode when not operational
– SCE 2000 Platform:
– deployment type
– physically-connected-link index
– priority
– on-failure link behavior
For a complete description of the command, see the Cisco SCE 2000 4xGBE Installation and
Configuration Guide.
Authorization: admin
Examples The following example runs the setup utility.
SCE>enable 10
Password:<cisco>
SCE#setup 
--- System Configuration Dialog ---
At any point you may enter a question mark ‘?’ followed by ‘Enter’ for help.
Use ctrl-C to abort configuration dialog at any prompt.
Use ctrl-Z to jump to the end of the configuration dialog at any prompt.
Default settings are in square brackets ‘[]’.
Would you like to continue with the System Configuration Dialog? [yes/no]: y