Specifications

2-298
Cisco SCE 2000 and SCE 1000 CLI Command Reference
OL-26797-03
Chapter 2 CLI Command Reference
setup
Command Modes Privileged EXEC
Command History This table includes the following release-specific history entries:
Usage Guidelines Following is a brief list of the parameters configured via the setup command:
• Host ID parameters: IP address, subnet mask, and hostname
• Passwords: admin password, password encryption
The root password can be configured upon initial system configuration and when accessed from the
root user.
• Time settings: time zone, offset from UTC, local time and date
• SNTP configuration: multicast client, unicast server, unicast query interval
link bypass mode on
operational status
When the SCE 1000 is operational, should it bypass traffic or not?
redundant SCE 1000
platform?
Is there a redundant SCE 1000 installed as a backup?
link bypass mode on
non-operational status
When the SCE 1000 is not operational, should it bypass traffic or cut it off?
Topology
Configuration (SCE
2000)
type of deployment Is this a cascade topology, with two SCE platforms connected via the
cascade ports? Or is this a single platform topology?
physically connected
link (cascade topology
only)
In a cascade deployment this parameter sets the index for the link that this
SCE 2000 is deployed on.
The options for the SCE 2000 are:
• link-0
• link-1
In a single-SCE 2000 Platform deployment this parameter is not relevant,
since one SCE 2000 is deployed on both links. In this case, the links are
designated as follows:
• The link connected to port1-port2 is by default link-0
• The link connected to port3-port4 is by default link-1
priority (cascade
topology only)
If this is a cascaded topology, is this SCE 2000 the primary or secondary
SCE 2000?
on-failure behavior
(inline connection
mode only)
If this SCE 2000 is deployed inline, should the failure behavior be bypass
or cutoff of the link?
Release Modification
2.5.7 This command was introduced.