Specifications

2-297
Cisco SCE 2000 and SCE 1000 CLI Command Reference
OL-26797-03
Chapter 2 CLI Command Reference
setup
RDR Formatter
Destination
Configuration
list entries (maximum 20 per list) IP address, and whether permitted or
denied access. IP access ACL ID number of the ACL controlling IP access.
telnet ACL ID number of the ACL controlling telnet access.
IP address IP address of the RDR-formatter destination.
TCP port number TCP port number of the RDR-formatter destination
Access Control Lists
Access Control List
number
How many ACLs will be necessary?
What IP addresses will be permitted/denied access for each management
interface?
You may want ACLs for the following:
• Any IP access
• Telnet access
• SNMP GET access
• SNMP SET access
list entries (maximum
20 per list)
IP address, and whether permitted or denied access.
IP access ACL ID number of the ACL controlling IP access.
telnet ACL ID number of the ACL controlling telnet access.
SNMP Configuration
SNMP agent status Enable or disable SNMP management.
GET community
names
Community strings to allow GET access and associated ACLs (maximum
20).
SET community
names
Community strings to allow SET access and associated ACLs (maximum
20).
trap managers Trap manager IP address, community string, and SNMP version (maximum
20).
Authentication Failure
trap status
Sets the status of the Authentication Failure traps.
enterprise traps status Sets the status of the enterprise traps.
system administrator Name of the system administrator.
Topology
Configuration (Both
Platforms)
connection mode Is the SCE platform installed in bump-in-the-wire topology (inline) or out
of line using a optical splitter (receive-only)?
Admin status of the
SCE platform after
abnormal boot
After a reboot due to a failure, should the SCE platform remain in a Failure
status or move to operational status provided no other problem was
detected?
Topology
Configuration (SCE
1000)