Specifications

2-287
Cisco SCE 2000 and SCE 1000 CLI Command Reference
OL-26797-03
Chapter 2 CLI Command Reference
service-bandwidth-prioritization-mode
service-bandwidth-prioritization-mode
Defines the service bandwidth prioritization mode.
service-bandwidth-prioritization-mode {global | subscriber-internal}
Syntax Description This command has no arguments.
Command Default default = subscriber-internal
Command Modes Interface Linecard Configuration
Command History This table includes the following release-specific history entries:
Usage Guidelines This parameter configures how bandwidth controllers compete for bandwidth by specifying which
assurance level (AL) value is used when allocating bandwidth between bandwidth controllers. The AL
can either be taken from either of the following:
• global prioritization mode — the global controller AL is taken from current bandwidth controller
Assurance Level.
• subscriber-internal prioritization mode — the global controller AL of each bandwidth controller
is taken from the Primary BWC Relative Priority (the party or “total” bandwidth-controller
Relative-Priority value)
Authorization: admin
Examples The following example shows how to use this command.
SCE>enable 10
Password:<cisco>
SCE#configure
SCE(config)#interface linecard 0
SCE(config if)#service-bandwidth-prioritization-mode global

SCE(config if)#
Related Commands
Release Modification
3.0.5 This command was introduced.
Command Description
show interface
linecard
service-bandwidth-pri
oritization-mode
Displays the currently configured service bandwidth prioritization mode.