Specifications

2-236
Cisco SCE 2000 and SCE 1000 CLI Command Reference
OL-26797-03
Chapter 2 CLI Command Reference
pqi upgrade file
pqi upgrade file
Upgrades the application using the specified pqi file and the upgrade options specified (if any). This may
take up to 5 minutes.
pqi upgrade file filename [options options ]
Syntax Description
Command Default This command has no default settings.
Command Modes Linecard Interface Configuration
Command History This table includes the following release-specific history entries:
Usage Guidelines A given pqi upgrade file is suitable for upgrading only from specific previously installed pqi files. The
upgrade procedure checks that an upgrade is possible from the currently installed pqi file. The upgrade
procedure will be stopped with an error message if the upgrade is not possible.
When upgrading the application in a cascaded system, use the force failure-condition command to force
failure in the active SCE 2000 platform (see 'System Upgrades in the Cisco SCE 2000 and SCE 1000
Software Configuration Guide).
Authorization: admin
Examples The following example upgrades the Subscriber Manager using the anr100155.pqi file. No options are
specified.
SCE>enable 10
Password:<cisco>
SCE#config
SCE(config)#interface linecard 0
SCE(config if)#pqi upgrade file anr100155.pqi

SCE(config if)#
filename The filename of the pqi application file to be used for the upgrade.
options The desired upgrade options. Use the show pqi file command to display the
available options.
Release Modification
2.5.7 This command was introduced.