Specifications

2-129
Cisco SCE 2000 and SCE 1000 CLI Command Reference
OL-26797-03
Chapter 2 CLI Command Reference
ip address
ip address
Sets the IP address and subnet mask of the Management Interface.
ip address new-address subnet-mask
Syntax Description
Command Default This command has no default settings.
Command Modes Mng Interface Configuration
Command History This table includes the following release-specific history entries:
Usage Guidelines When both management ports are connected, only one port is active at any given time, while the second
management port provides a redundant management interface. In this case, the configured IP address
acts as a virtual IP address for the currently active management interface, regardless of which port is the
active port.
Since this IP address always acts as a virtual IP address for the currently active management port, this
command can be executed from the Mng Interface Configuration for either management port.
Note Changing the IP address of the management interface via telnet will result in loss of the telnet connection
and inability to reconnect with the interface.
Note After changing the IP address, you must reload the SCE platform (see reload ) so that the change will
take effect properly in all internal and external components of the SCE platform.
If there is a routing table entry mapped to the old address, but not to the new address, the command may
fail.
Authorization: admin
new-address The new IP address.
subnet-mask The network mask for the associated IP network.
Release Modification
2.5.7 This command was introduced.