Specifications

2-126
Cisco SCE 2000 and SCE 1000 CLI Command Reference
OL-26797-03
Chapter 2 CLI Command Reference
interface range gigabitethernet
interface range gigabitethernet
Enters GigabitEthernet Interface Configuration mode for two or more GBE line interfaces.
interface range gigabitethernet slot-number/interface-range
Syntax Description
Command Default This command has no default settings.
Command Modes Global configuration
Command History This table includes the following release-specific history entries:
Usage Guidelines The interface range command allows you to perform a CLI operation on a group of interfaces with one
command, with the limitation that all the interfaces in the group must be of the same physical and logical
type.
• To return to the Global Configuration Mode, use the exit command.
• To return to the Use Exec authorization level, use the end command.
The system prompt changes to reflect the GigabitEthernet Interface Configuration mode.
The following commands will be executed on all interfaces specified in the interface range
gigabitethernet command as long as you remain in the GigabitEthernet Interface Configuration mode:
• auto-negotiate
• global-controller bandwidth
• global-controller name
Authorization: admin
slot-number Enter a value of 0.
interface-range Specify the range of ports in the format ‘port1-port2’, where the overall
range of possible port numbers is as follows:
• SCE 2000: 1-4
• SCE 1000: 1-2
Release Modification
3.0.3 This command was introduced.