Specifications

2-121
Cisco SCE 2000 and SCE 1000 CLI Command Reference
OL-26797-03
Chapter 2 CLI Command Reference
interface gigabitethernet
interface gigabitethernet
Enters GigabitEthernet Interface Configuration mode to configure a specified Gigabit Ethernet line
interface. To configure a management port, use the interface mng command.
interface gigabitethernet slot-number/interface-number
Syntax Description
Command Default This command has no default settings.
Command Modes Global configuration
Command History This table includes the following release-specific history entries:
Usage Guidelines Use this command to configure the line ports for an SCE 2000 4xGBE or SCE 1000 2xGBE platform.
This command is not used for configuring the management ports.
• To return to the Global Configuration Mode, use the exit command.
• To return to the Use Exec authorization level, use the end command.
The SCE 1000 platform uses line ports 1-2 and the SCE 2000 platform uses line ports 1-4.
The system prompt changes to reflect the GigabitEthernet Interface Configuration mode.
Authorization: admin
Examples The following example enters into GigabitEthernet Configure Interface Mode to configure line port 1.
SCE>enable 10
Password:<cisco>
SCE#config
SCE(config)#interface gigabitethernet 0/1

SCE(config if)#
slot-number Enter a value of 0.
interface-number The GigabitEthernet line interface number.
• SCE 2000 4xGBE platform: Enter a value between 1 and 4
• SCE 1000 2xGBE platform: Enter a value of either 1 or 2
Release Modification
2.5.7 This command was introduced.