Specifications

2-71
Cisco SCE 2000 and SCE 1000 CLI Command Reference
OL-26797-03
Chapter 2 CLI Command Reference
connection-mode (SCE 2000 platform)
connection-mode (SCE 2000 platform)
Sets the connection mode parameters for an SCE 2000 platform.
connection-mode connection-mode sce-id sce-id priority priority on-failure on-failure
Syntax Description
Command Default connection mode = inline
sce-id = 0
priority = primary
on-failure = bypass
Command Modes Linecard Interface Configuration
connection-mode
• inline : single SCE platform inline
• receive-only : single SCE platform receive-only
• inline-cascade : two SCE platforms inline
• receive-only-cascade : two SCE platforms receive-only
sce-id A number that identifies the SCE platform in a cascaded pair.
The sce-id parameter, which identifies the SCE platform, replaces the
physically-connected-link parameter, which identified the link. This change was
required with the introduction of the SCE8000 GBE platform, which supports
multiple links. In the SCE2000, the number assigned to the sce-id parameter (0
or 1) will be defined as the of number of the physically-connected-link.
Note that for backwards compatibility, the physically-connected-link parameter
is currently still recognized.
(cascaded SCE platform topology only)
• 0
• 1
priority Defines the primary SCE platform. (cascaded SCE platform topologies only).
• primary
• secondary
on-failure Determines system behavior on failure of the SCE platform. (inline topologies
only)
• bypass
• cutoff