Technical information

Workbench or Tabletop Installation

Figure 1: Installing the System on a Flat Surface

For a workbench or tabletop installation, verify the following before installing the SCE 1000 platform:

• The SCE 1000 platform is off the floor and has adequate ventilation.

• An adequate chassis ground (earth) connection exists for the SCE 1000 platform.

• The SCE 1000 platform has at least 2 inches (5 cm) of clearance at each side and at least 5 inches (12.7 cm) of

clearance at the rear to allow proper air flow.

Step 1 Remove the adhesive strips from the four rubber feet and affix the feet onto the four marked locations on the

bottom panel of the unit.

Step 2 Place the SCE 1000 platform on the tabletop or workbench.