Technical information

45
Step 1 To enter the Global Configuration Mode, at the SCE 1000# prompt, type configure, and press Enter.
The SCE 1000(config)# prompt appears.
Step 2
To enter the desired GBE port interface, type interface GigabitEthernet 0/portnumber, and press Enter,
where portnumber is the number of the selected port (1 or 2).
The SCE 1000(config if)# prompt appears.
Step 3
Type auto-negotiate and press Enter.
The SCE 1000(config if)# prompt appears.
Step 4
To return to Global Configuration Mode, type exit and press Enter.
The SCE 1000(config)# prompt appears.
Repeat this procedure to configure auto-negotiation for the other GBE port interfaces as needed.
Connect the GBE Line Interface Ports
Figure 16: Cabling the GBE Interface