User guide

Chapter 4 Installation and Startup
System Configuration
SCE 1000 2xGBE Release 2.0.10 User Guide
OL-7117-02 4-27
Parameter Definition
unicast query interval Interval in seconds between unicast requests for update (64 – 1024)
unicast server IP address IP address of the SNTP unicast server.
DNS Configuration
DNS lookup status Enable or disable IP DNS-based hostname translation.
default domain name Default domain name to be used for completing unqualified host names
IP address IP address of domain name server. ( maximum of 3 servers)
RDR Formatter Destination Configuration
IP address IP address of the RDR-formatter destination
TCP port number TCP port number of the RDR-formatter destination
Access Control Lists
Access Control List
number
How many ACLs will be necessary? What IP addresses will be
permitted/denied access for each management interface? You may want
ACLs for the following :
• Any IP access
• Telnet access
• SNMP GET access
• SNMP SET access
list entries (maximum 20
per list)
IP address, and whether permitted or denied access.
IP access ACL ID number of the ACL controlling IP access.
telnet ACL ID number of the ACL controlling telnet access.
SNMP Configuration
SNMP agent status Enable or disable SNMP management.
GET community names Community strings to allow GET access and associated ACLs (maximum
20).
SET community names Community strings to allow SET access and associated ACLs (maximum
20).
trap managers Trap manager IP address, community string, and SNMP version.
(maximum 20)
Authentication Failure
trap status
Set the status of the Authentication Failure trap. (See Traps (on page 6-
34).)
enterprise traps status Set the status of the enterprise traps. (See Traps (on page 6-34).)
system administrator Name of the system administrator.
Topology Configuration
connection mode Is the SCE 1000 installed in bump-in-the-wire topology (inline) or out of
line using a switch with port mirroring (receive-only)?
link bypass mode on
operational status
When the SCE 1000 is operational, should it bypass traffic or not?
Refer, in setup, to the table Setup Command Parameters.