User guide

Chapter 4 Installation and Startup
Connecting to the Power Supply
SCE 1000 2xGBE Release 2.0.10 User Guide
OL-7117-02 4-13
Step 4 While keeping the brackets flush against the posts or mounting strips, align the holes in
the brackets with the holes on the rack or mounting strip.
Figure 4-9: Securing the SCE 1000 to a the Rack
Step 5 For each bracket, insert and tighten two appropriate screws to the rack.
Note
Since the brackets support the weight of the entire SCE 1000 chassis, be sure to use all four screws to
fasten the two rack-mount brackets to the rack posts.
This completes the procedure for installing the SCE 1000 in the rack. Proceed to the next
section, Connecting to the Power Supply, to continue the installation.
Connecting to the Power Supply
The SCE 1000 is available in two power options:
• Dual line feed AC power: Unit comes with two appropriate AC power supply cords
• Dual line feed DC power: requires appropriate cables (hex or loop connectors) (see
Connecting the DC Power Supply).