User guide

Chapter 3 Command Line Interface
Authorization and Command Levels (Hierarchy)
SCE 1000 2xGBE Release 2.0.10 User Guide
OL-7117-02 3-9
EXAMPLE:
The following example shows how to enter Configuration Mode for the GigabitEthernet
Interface number 2.
SCE 1000(config)#interface GigabitEthernet 0/2
SCE 1000(config if)#
Navigating between the Interface Configuration Modes
To navigate from one Interface Configuration Mode to another:
Step 1 Type exit.
You are returned to the Global Configuration Mode.
Step 2 Type the appropriate command to enter a different Interface Configuration Mode.
Interface Configuration Modes
The interfaces that are configured by the Interface Configuration Modes are:
• LineCard: Interface LineCard 0
The LineCard interface configures the main functionality of viewing and handling traffic on
the line.
• Fast Ethernet Management: Interface FastEthernet 0/0
The FastEthernet Management Interface configures the settings for the interface to other
network elements within the system. This interface should be connected to the internal
Ethernet within the operator’s site.
• Gigabit Ethernet: Interface GigabitEthernet 0/1, 0/2, 0/3, or 0/4
The GigabitEthernet Interface mode configures the settings for the GigabitEthernetinterface to
the Internet traffic on the wire. Each of the four ports can be set individually.
• Line Configuration Mode: Line vty 0
Line Configuration Mode enables you to configure Telnet parameters.
Exiting Modes
This section describes how to revert to a previous mode. When you use the exit command you
revert to the general level above the current level, as shown in the figure in CLI Command
Hierarchy.
To exit from the Privileged Exec mode and revert to the User Exec mode:
Step 1 At the SCE 1000# prompt, type disable, and press Enter.
The SCE 1000> prompt for the User Exec mode appears.