User guide

Chapter 3 Command Line Interface
Authorization and Command Levels (Hierarchy)
SCE 1000 2xGBE Release 2.0.10 User Guide
3-6 OL-7117-02
To move from one interface configuration mode to another you must exit the current interface
configuration mode (as illustrated in the above figure).
Note
Although the system supports up to five concurrent Telnet connections, you cannot configure them
separately. This means that any number you enter in the line vty command (0, 1, 2, 3 or 4) will act as
a
0 and configure all five connections together.
EXAMPLE:
This example illustrates moving into and out from Interface configuration mode as follows:
• Configure the SCE 1000 time zone (global configuration)
• Enter Interface configuration mode
• Configure the speed of the management interface
• Define the operational bypass mode.
• Exit Interface configuration mode
SCE 1000#>configure
SCE 1000(config)#>clock timezone PST -10
SCE 1000(config)#>interface FastEthernet 0/0
SCE 1000(config if)#>speed 100
SCE 1000(config)#>exit
SCE 1000(config)#>interface LineCard 0
SCE 1000(config if)#>link-bypass on-operational no-bypass
SCE 1000(config if)#>exit
Entering and Exiting Global Configuration Mode
To enter the Global Configuration Mode:
Step 1 At the SCE 1000# prompt, type configure, and press Enter.
The SCE 1000(config)# prompt appears.
To exit the Global Configuration Mode:
Step 1 At the SCE 1000(config)# prompt, type exit and press Enter.
The SCE 1000# prompt appears.
Interface Configuration Modes
The interfaces that are configured by the Interface Configuration Modes are:
• LineCard: Interface LineCard 0