User guide

Appendix A
LineCard Interface Configuration Mode Commands
SCE 1000 2xGBE Release 2.0.10 User Guide
OL-7117-02 A-51
Flags = RST flag when value = 1 and all ACK flag values
Direction = downstream
Traffic counter = counter2
Action = Block
The actions performed will be counting and blocking
SCE 1000 (config if)# traffic-rule rule2 IP-addresses subscriber-side all
network-side all-but 10.10.10.0/24 protocol TCP ports subscriber-side 100
network-side 100:150 flags RST 1 ACK all direction downstream traffic-
counter counter2 action block
EXAMPLE 2
This example creates the following traffic rule:
Name = rule3
IP addresses: all
Protocol = IS-IS
Direction = upstream
Traffic counter = none
Action = ignore (required since traffic-counter = none)
Since it is not TCP/UDP, port and flags are not applicable.
The only action performed will be Ignore.
SCE 1000 (config if)# traffic-rule rule3 IP-addresses all protocol IS-IS
direction upstream traffic-counter none action ignore
EXAMPLE 3
The following example demonstrates how to delete all traffic rules.
SCE 1000(config if)# no traffic-rule all
[no] ip tunnel mode
Configures recognition of L2TP tunnels and skipping into the internal IP packet. User the no
form of this command to disable tunnel recognition.
An IP tunnel is mutually exclusive with using VLAN for classification.
default disabled (no)
Authorization admin
Mode LineCard Interface Configuration
E
XAMPLE:
The following example enables recognition of L2TP tunnels.
SCE 1000(config if)#ip tunnel L2TP skip