User guide

Chapter 8 Managing Subscribers
Monitoring Subscribers
SCE 1000 2xGBE Release 2.0.10 User Guide
8-12 OL-7117-02
Displaying Subscribers
You can display specific subscriber name(s) that meet various criteria:
• A subscriber property is equal to, larger than, or smaller than a specified value
• Subscriber name matches a specific prefix or suffix
• Mapped to a specified IP address range
• Mapped to a specified VLAN ID
Use the following commands to display subscribers:
• show interface linecard 0 subscriber [amount]
• [prefix ‘prefix’] [property ‘propertyname’ equals|greater-than|less-
than ‘property-val’]
• show interface linecard 0 subscriber [amount] prefix ‘prefix’
• show interface linecard 0 subscriber [amount] suffix ‘suffix’
• show interface linecard 0 subscriber mapping IP ‘iprange’
• show interface linecard 0 subscriber [amount] mapping intersecting IP
‘iprange’
• show interface linecard 0 subscriber mapping VLANid ‘vlanid’
Displaying Subscribers: By Subscriber Property or Prefix
You can search for all subscribers that match a specified value of one of the subscriber properties,
or are greater than or less than the specified value. You can also search for all subscribers that
match a specified prefix. You can also find out how many subscribers match any one of these
criteria, rather than displaying all the actual subscriber names.
To display subscribers that match a specified value of a subscriber property:
Step 1 From the SCE 1000# prompt, type show interface linecard 0
subscriber property ‘propertyname’ equals ‘property-val’ and
press Enter.
To display subscribers that are greater than or less than a specified value of a subscriber property:
Step 1 From the SCE 1000# prompt, type show interface linecard 0
subscriber property ‘propertyname’ greater-than|less-than
‘property val’ and press Enter.