User guide

Chapter 7 Line Configuration
Editing the Connection Mode
SCE 1000 2xGBE Release 2.0.10 User Guide
OL-7117-02 7-13
Modifying the TOS Table
To modify the TOS table:
Step 1 From the SCE 1000(config if)# prompt, type tos-marking set-table-
entry class class color color value value and press Enter.
class is the applicative class of the packet (BE, AF1, AF2, AF3, AF4, EF),, color is
the applicative color (green, red or any) and value is the value to be assigned to the
packet (value set to the IP TOS field). The value parameter must be in hexadecimal
format in the range 0x0 to 0x3f.
EXAMPLE:
The following example sets a TOS marking table entry.
SCE 1000 (config if)#tos-marking set-table-entry class AF3 color green value
0x24
Editing the Connection Mode
The connection mode command allows you to configure the topology of the system in one
command. The connection mode is determined by the physical installation of the SCE 1000.
There are two topology-related parameters included in the connection mode command:
• Connection mode: Can be either of the following, depending on the physical installation of
the SCE 1000:
• Inline connection mode: Bump-in-the-wire installation.
• Receive-only connection mode: Out-of-line installation utilizing an external switch or
splitter.
The default value is inline.
• On-failure: This parameter determines how the behavior of the bypass mechanism of the
SCE 1000 when it either has failed or is booting.
• Bypass: The bypass mechanism preserves the network link, but traffic is not processed for
monitoring or for control
• Cutoff: There is no forwarding of traffic, and the physical link is forced down (cutoff
functionality at layer 1).
Default: bypass
Note
Do not change the connection mode unless the physical installation has been changed.