User guide

Chapter 6 Control Configuration
Entering LineCard Interface Configuration Mode
SCE 1000 2xGBE Release 2.0.10 User Guide
6-46 OL-7117-02
To install an application:
Step 1 From the SCE 1000(config if)# prompt, type pqi install file filename
[options] and press Enter.
The specified pqi file is installed using the installation options specified (if any) and the
SCE 1000(config if)# prompt appears.
Note that this may take up to 5 minutes.
Note
Always run the pqi uninstall command before installing a new pqi file.
To uninstall an application:
Step 1 From the SCE 1000(config if)# prompt, type pqi uninstall file
filename and press Enter.
The specified pqi file is uninstalled and the SCE 1000(config if)# prompt appears.
You must specify the same pqi file that was installed.
Note that this may take up to 5 minutes.
To upgrade an application:
Step 1 From the SCE 1000(config if)# prompt, type pqi upgrade file filename
[options] and press Enter.
The specified pqi file is upgraded using the options specified (if any) and the SCE
1000(config if)# prompt appears.
You must specify the pqi file that was last used for upgrade.
Note that this may take up to 5 minutes.