User guide

Chapter 6 Control Configuration
Entering FastEthernet (Management) Interface Configuration Mode
SCE 1000 2xGBE Release 2.0.10 User Guide
6-42 OL-7117-02
To edit the failure recovery operational mode:
Step 1 From the SCE 1000(config)# prompt, type failure-recovery operation-
mode operational|non-operational and press Enter.
Enter either the value operational or non-operational.
EXAMPLE 1:
The following example sets the system to boot as operational after a failure
SCE 1000(config)#failure-recovery operation-mode operational
SCE 1000(config)#
EXAMPLE 2:
The following example sets the system to the default failure recovery mode.
SCE 1000(config)# default failure-recovery operation-mode
SCE 1000(config)#
Entering FastEthernet (Management) Interface Configuration Mode
Before you can configure the FastEthernet parameters for the management interface, you must be
in the FastEthernet Management Interface Configuration Mode.
To enter FastEthernet Management Interface Configuration Mode:
Step 1 To enter Global Configuration Mode, type configure and press Enter.
The SCE 1000(config)# prompt appears.
Step 2 Type interface FastEthernet 0/0 and press Enter.
The SCE 1000(config if)# prompt appears.
The system prompt changes to reflect the higher level mode.
To return to the Global Configuration mode:
Step 1 Type exit.