User guide

Chapter 6 Control Configuration
SNMP Configuration and Management
SCE 1000 2xGBE Release 2.0.10 User Guide
OL-7117-02 6-35
Configuring Traps
By default, the SCE 1000 is not configured to send any SNMP traps. You must define the
Network Management System to which the SCE 1000 should send traps. (See the table below,
Configurable Traps, for a list of configurable traps). Whenever one of the events that trigger traps
occurs in the SCE 1000, an SNMP trap is sent from the SCE 1000 to the list of IP addresses that
you define.
SCE 1000 supports two general categories of traps:
• Standard SNMP traps: As defined in RFC1157 and using the conventions defined in
RFC1215.
• Proprietary SCE enterprise traps: As defined in the SCE proprietary MIB.
After a host is configured to receive traps, by default, the SCE 1000 sends to this host all the traps
supported by the SCE 1000 except for the AuthenticationFailure trap. The SCE 1000 provides the
option to enable or disable the sending of this trap, as well as some of the SCE enterprise traps,
explicitly.
SCE 1000 can be configured to generate either SNMPv1 style or SNMPv2c style traps. By
default, the SCE 1000s sends SNMPv1 traps.
Following the table are sample procedures displaying how to configure a host (NMS) to which the
SNMP agent should send traps; how to enable the SNMP agent to send authentication-failure
traps; how to reset all traps to the default setting, and how to remove/disable a host (NMS) from
receiving traps.
Table 6-2 Configurable Traps
Traps Description Trap Names Default
Standard Traps
Authentication
Failure
An authenticationFailure trap is
sent when the SCE 1000 is the
addressee of a protocol message
that is not properly authenticated.
authenticationFailure Disabled
Enterprise Traps
attack filter An attack filter trap is sent when an
attack filter has been activated or
deactivated. The type of attack-
filter that was activated is returned
in pcubeSeEventGenericString1
moduleAttackFilterActivatedTra
p
moduleAttackFilter
DeactivatedTrap
Disabled
chassis A chassis trap is sent when an
environmental alarm condition
occurs in the SCE 1000 or is
resolved.
chassisTempAlarmOnTrap
chassisTempAlarmOffTrap
chassisVoltageAlarmOnTrap
chassisFansAlarmOnTrap
chassisPowerSupplyAlarmOn
Trap
Enabled