User guide

Chapter 5 Configuration and Management
Entering and Exiting Global Configuration Mode
SCE 1000 2xGBE Release 2.0.10 User Guide
OL-7117-02 5-19
To disable password encryption:
Step 1 From the SCE 1000(config)# prompt, type no service password
encryption.
This does not remove the encryption from the configuration file. You must save to the
startup configuration file if you want the password to be stored un-encrypted on the
startup configuration file.
Note
Once the system is secured, you cannot recover a lost or forgotten password. Contact your Cisco
customer support center if the password is lost.
Upgrading SCE Platform Firmware
Cisco distributes upgrades to the software and firmware on the SCE 1000. Cisco distributes
upgrade software as a file with the extension .pkg that is installed directly from the ftp site
without being copied to the disk. This procedure walks you through installation and rebooting of
the SCE 1000 with the new firmware.
To upgrade your SCE 1000 software:
Step 1 Type configure to enter Global Configuration mode.
The SCE prompt changes to SCE 1000(config)#.
Step 2 Type boot system
ftp://<user:password@host/drive:dir/seNum.pkg>, where
<seNum.pkg> is the file name on the ftp site.
The boot command verifies that the package is a legal, appropriate update for the SCE
1000 and that the file was not corrupted. It does not perform an upgrade, but does keep
in the system memory that a pkg file is available.
Step 3 Type exit to leave the Global Configuration mode.
The SCE prompt changes to SCE 1000#.
Step 4 Type copy running-config startup-config.
This command re-verifies that the package is valid, and extracts the upgrade to the Flash
file system.
The system notifies you that it is performing the extraction as follows: