Datasheet

Release Notes for Catalyst 4500 Series Software Release 7.x

OL-1983-28

Software Documentation Updates for Release 7.1

• There is a problem when you highlight the MultiChannel DS3 Port Adapter in the WS-X6182-PA

module, and then select Configure > Interface. The dialog box displays “n/a” or the incorrect

values in every field. Also, if you select Monitor > Interface, the charts in the resulting dialog box

do not get updated, and an error message is displayed in the status bar. (CSCdr39591)

• The LED labeled RPS is not supported on Catalyst 2948G and 2980G devices. (CSCdw38266)

• Daughter cards on the WS-X4604-GWY card are not supported. (CSCdw51541)

• Deleting the primary VLAN in the VLAN and Bridge dialog box after unbinding the secondary

VLAN causes an error message to be displayed.

Workaround: Close and reopen the VLAN and Bridge dialog box; delete the primary VLAN.

(CSCdt65530)

• After binding a secondary VLAN to the primary VLAN, delete the primary VLAN. This error

message is displayed:

Set failed due to snmpRspGenErr for vtpVlanEditRowStatus1.199.

Workaround: Close and reopen the VLAN and Bridge dialog box. The correct message displays.

(CSCdt65530)

• Ports G1 and G2 on the WS-X4232-L3 card will always show the presence of GBIC modules.

(CSCdr29617)

• 802.1X authentication timer fields are available in the port level PAE dialog box. (CSCdw86044)

• When a device is set to MST Spanning Tree mode, the path cost and priority fields in the Bridge

Details dialog box cannot be set on a channeling port that is using PAGP or LACP. (CSCdx23200

and CSCdx23217)

• In the EtherChannel dialog box, when EtherChannel Operation Mode is changed from pagpon to

either off or manual, click the Refresh button and the PAgP dialog box displays N/A for every field.

Workaround: Close and reopen the EtherChannel dialog box. (CSCdw76309)

Software Documentation Updates for Release 7.1

This section describes caveats for the Catalyst 4500 series software release 7.1 documentation. These

changes will be included in the next update to the documentation.

• Link Aggregation Control Protocol (LACP), which is defined in IEEE 802.3ad, allows Cisco

switches to manage Ethernet channeling with devices that conform to the 802.3ad specification.

Prior to software release 7.1(1), PAgP was available. PAgP is a Cisco-proprietary protocol that can

be run only on Cisco switches and those switches released by licensed vendors.