Datasheet

Release Notes for Catalyst 4500 Series Software Release 7.x

OL-1983-28

Usage Guidelines, Restrictions, and Troubleshooting

Step 6 Select Edit > Preferences, and then click Advanced in the navigation tree.

Step 7 Make sure that the “Enable Java” check box is not selected.

Step 8 Specify the IP address of the device that you want to access and launch CiscoView. The Java console is

displayed, but the chassis view does not appear.

Step 9 Select Edit > Preferences, and then click Advanced in the navigation tree.

Step 10 Select the “Enable Java” check box.

Step 11 Specify the IP address of the device that you want to access and launch CiscoView. Both the Java console

and chassis view should display.

• If you are running Netscape Navigator with a Java Plug-in version that is earlier than version 1.3.0,

you might get a blank screen when you launch CiscoView. (CSCdw59601)

To correct the problem, download Java Plug-in 1.3.0 or later from this location:

http://www.cisco.com/cgi-bin/tablebuild.pl/cview-plugin

• If your machine is running Windows 2000, Windows NT, or Windows 98 and the chassis view does

not appear, you should disable the Java Plug-in’s JAR caching feature, as follows:

–

For Java Plug-in 1.3.1:

1) Select Start > Settings > Control Panel > Java Plug-in 1.3.1.

2) Click the Cache tab.

3) Click Clear JAR Cache.

–

For Java Plug-in 1.3.0:

1) Select Start > Settings > Control Panel > Java Plug-in.

2) Click the Basic tab.

3) Make sure the “Cache JARs In Memory” check box is not selected.

4) Click Apply.

• If your machine runs on the HP-UX platform, we recommend that you use the HP release of

Netscape. The HP release of Netscape can be downloaded from this location:

http://h30097.www3.hp.com/internet/comm479_form.html

(CSCdw59617)

• CiscoView images take approximately 12 minutes to download from a TFTP server to a PCMCIA

Flash memory card. (CSCdr14437)

• In the VLAN & Bridge dialog box (Device > Configure > VLAN & Bridge), deleting the primary

VLAN after unbinding the secondary VLAN returns an error message. The workaround is to close

and reopen the dialog box and then delete the primary VLAN.

After binding a secondary VLAN to the primary VLAN, delete the primary VLAN and the following

error message is displayed: “Set failed due to snmpRspGenErr for vtpVlanEditRowStatus.1.199.”

The workaround is to close and then reopen the dialog box. You should now see the correct error

message: “The Primary is bounded ...” (CSCdt65530)

• Disabled WAN modules are placed in the power-down state. (CSCdw50083)

• The Carrier Alarm LED on WAN modules is not supported. (CSCdw50111)