User guide

4
Property of TheGreenBow – Sistech S.A. © 2014
IPsec VPN Router Configuration
Configuration Guide
2 Cisco RV220W VPN configuration
This section describes how to build an IPsec VPN configuration with your Cisco RV220W VPN router.
Once connected to your Cisco RV220W VPN gateway, follow the steps below.
2.1 Configure VPN using Wizard
Navigate to the menu > VPN > Advanced VPN Setup > IKE Policy Table > Add
2.2 Add IKE Policy
Below screenshot shows the typical settings to be used for IPSec VPN
Take note of the values set here as they would be required when configuring the TheGreenBow VPN Client.
The important values include:
Pre-Shared Key: This can be any text string, preferably complex for security
Remote WAN IP address/FQDN: This can be remote.com or any other arbitrary value e.g. tywoddse1.com but
the corresponding value used in TheGreenBow VPN Client must be the same. It does not have to be a real
address i.e. resolve to a real IP address.
Local WAN IP address/FQDN: This can be local.com or any arbitrary value e.g. yywox99.com. The value does
not matter, but the same value must be entered in the corresponding field in the TheGreenBow VPN Client. It
does not have to be a real address i.e. resolve to a real IP address.
Local LAN IP address and subnet: This must match the LAN subnet of the Cisco RV220W router.
Click the "Save" button after entering the required information
Add IKE Policy
Chapter 2.2
Add VPN Policy
Chapter 2.4