User Manual
Table Of Contents
- Introduction
- Configuring Networking
- Configuring the Wireless Network
- Configuring the Firewall
- Configuring VPN
- Configuring Quality of Service (QoS)
- Administering Your Cisco RV110W
- Setting Password Complexity
- Configuring User Accounts
- Setting the Session Timeout Value
- Configuring Simple Network Management (SNMP)
- Using Diagnostic Tools
- Configuring Logging
- Configuring Bonjour
- Configuring Date and Time Settings
- Backing Up and Restoring the System
- Upgrading Firmware or Change the Language
- Restarting the Cisco RV110W
- Restoring the Factory Defaults
- Running the Setup Wizard
- Viewing the Cisco RV110W Status
- Using Cisco QuickVPN
- Where to Go From Here
5
Cisco RV110W Administration Guide 95
Configuring VPN
This chapter describes how to configure VPN and security for the Cisco RV110W.
• VPN Tunnel Types, page 95
• VPN Clients, page 96
• Configuring Certificate Management, page 108
• Configuring VPN Passthrough, page 109
VPN Tunnel Types
A VPN provides a secure communication channel (“tunnel”) between two gateway
routers or a remote worker and a gateway router. You can create different types of
VPN tunnels, depending on the needs of your business. Several scenarios are
described below. Read these descriptions to understand the options and the
steps required to set up your VPN.
Remote access using PPTP
In this scenario, a remote user with a Microsoft computer connects to a PPTP
server at your site to access network resources. Use this option to simplify VPN
setup. You do not have to configure VPN policies. Remote users can connect by
using the PPTP client from a Microsoft computer. There is no need to install a VPN
client. However, be aware that security vulnerabilities have been found in this
protocol.
Enter the PPTP server settings and add the users on the VPN > VPN Clients page,
in the VPN Client Setting Table. Choose PPTP as the user protocol. See Creating
and Managing PPTP Users.