User Manual
Table Of Contents
- Introduction
- Configuring Networking
- Configuring the Wireless Network
- Configuring the Firewall
- Configuring VPN
- Configuring Quality of Service (QoS)
- Administering Your Cisco RV110W
- Setting Password Complexity
- Configuring User Accounts
- Setting the Session Timeout Value
- Configuring Simple Network Management (SNMP)
- Using Diagnostic Tools
- Configuring Logging
- Configuring Bonjour
- Configuring Date and Time Settings
- Backing Up and Restoring the System
- Upgrading Firmware or Change the Language
- Restarting the Cisco RV110W
- Restoring the Factory Defaults
- Running the Setup Wizard
- Viewing the Cisco RV110W Status
- Using Cisco QuickVPN
- Where to Go From Here
Configuring the Firewall
Configuring Basic Firewall Settings
Cisco RV110W Administration Guide 81
4
Configuring Basic Firewall Settings
To configure basic firewall settings:
STEP 1 Choose Firewall > Basic Settings.
STEP 2 Configure the following firewall settings:
Firewall Check Enable to configure firewall settings.
DoS Protection Check Enable to enable Denial of Service
protection.
Block WAN Request Blocks ping requests to the Cisco RV110W from
the WAN.
Web Access Choose the type of web access that can be used
to connect to the firewall: HTTP or HTTPS (secure
HTTP).
Remote Management
Remote Access
Remote Upgrade
Allowed Remote IP
Address
Remote Management
Port
See Configuring Remote Management.
IPv4 Multicast
Passthrough (IGMP
Proxy)
Check Enable to enable multicast passthrough for
IPv4.
IPv6 Multicast
Passthrough (IGMP
Proxy)
Check Enable to enable multicast passthrough for
IPv6.
UPnP
Allow Users to Configure
Allow Users to Disable
Internet Access
See Configuring Universal Plug and Play.