User Manual

Configuring the Wireless Network
Configuring Basic Wireless Settings
Cisco RV110W Administration Guide 69
3
STEP 3 In the Select SSID field, choose the SSID for which to configure the security
settings.
STEP 4 From the Security Mode menu, choose one of the three WPA Enterprise options.
STEP 5 (WPA-Enterprise only) In the Encryption field, choose one of the following options:
• TKIP/AES—Choose TKIP/AES to ensure compatibility with older wireless
devices that may not support AES.
• AES—This option is more secure.
STEP 6 In the RADIUS Server field, enter the IP address of the RADIUS server.
STEP 7 In the RADIUS Port field, enter the port used to access the RADIUS server.
STEP 8 In the Shared Key field, enter an alphanumeric phrase (8–63 ASCII characters or
64 hexadecimal digits).
STEP 9 In the Key Renewal field, enter the duration of time (600–7200 seconds) between
key renewals. The default value is 3600.
STEP 10 Click Save to save your settings.
STEP 11 Click Back to go back to the Basic Settings page.
Configuring MAC Filtering
You can use MAC Filtering to permit or deny access to the wireless network based
on the MAC (hardware) address of the requesting device. For example, you can
enter the MAC addresses of a set of computers and only allow those computers to
access the network. You can configure MAC Filtering for each network or SSID.
To configure MAC filtering:
STEP 1 In the Wireless Table (Wireless > Basic Settings), check the box for the network
you want to configure.
STEP 2 Click Edit MAC Filtering. The Wireless MAC Filter page appears.
STEP 3 In the Edit MAC Filtering field, check the Enable box to enable MAC Filtering for
this SSID.