User Manual
Table Of Contents
- Introduction
- Configuring Networking
- Configuring the Wireless Network
- Configuring the Firewall
- Configuring VPN
- Configuring Quality of Service (QoS)
- Administering Your Cisco RV110W
- Setting Password Complexity
- Configuring User Accounts
- Setting the Session Timeout Value
- Configuring Simple Network Management (SNMP)
- Using Diagnostic Tools
- Configuring Logging
- Configuring Bonjour
- Configuring Date and Time Settings
- Backing Up and Restoring the System
- Upgrading Firmware or Change the Language
- Restarting the Cisco RV110W
- Restoring the Factory Defaults
- Running the Setup Wizard
- Viewing the Cisco RV110W Status
- Using Cisco QuickVPN
- Where to Go From Here
A
Cisco RV110W Administration Guide 148
Using Cisco QuickVPN
Overview
This appendix explains how to install and use the Cisco QuickVPN software that
can be downloaded from Cisco.com. QuickVPN works with computers running
Windows 7, Windows XP, Windows Vista, or Windows 2000. (Computers using
other operating systems will have to use third-party VPN software.)
This appendix includes the following sections:
• Before You Begin
• Installing the Cisco QuickVPN Software
• Using the Cisco QuickVPN Software
Before You Begin
The QuickVPN program only works with a router that is properly configured to
accept a QuickVPN connection. You must perform the following steps:
STEP 1 Enable remote management. See Configuring Basic Firewall Settings.
STEP 2 Create Quick VPN user accounts. See Configuring PPTP. After a user account is
created, the credentials can be used by the Quick VPN client.